Combined infrared thermography and 3D scanning for evaluation of FDM‑printed PETG components

发布时间:2026-11-14 | 来源:Nature Scientific Reports | 分类:PETG | 作者:Małgorzata Chwał

The increasing availability of shipboard additive manufacturing (AM) enables on-board repair through the rapid fabrication of temporary polymer spare parts. Thi

The increasing availability of shipboard additive manufacturing (AM) enables on-board repair through the rapid fabrication of temporary polymer spare parts. This preliminary study assesses the thermo-geometric stability of FDM (Fused Deposition Modeling)-printed PETG components intended for short-term service. First, cylindrical PETG pipe specimens with wall thicknesses ranging from 1 to 2 mm were manufactured using different layer heights and printing speeds and subsequently evaluated under steady heating. Passive infrared thermography (IRT), combined with pre- and post-heating 3D scanning, was employed for analysis. Next, a reverse-engineered PETG replica of a flanged tee connector used in shipboard piping systems was fabricated and tested under the same thermal conditions. IRT revealed moderate temperature gradients associated with the vertical heating configuration; nevertheless, 3D deviation maps indicated only minor dimensional changes, comparable to those observed in the pipe specimens. The experiments suggested that rapid thermal and thermo-mechanical loading may lead to layer separation in FDM-printed specimens. Infrared thermography provided information on the thermal response of the specimens, while delamination was identified through post-test visual inspection. Under steady heating conditions, the investigated specimens exhibited stable thermal and geometric behavior, with only minor dimensional deviations observed. Overall, the results suggest that PETG parts printed using time-efficient process parameters may have potential for use as temporary components under steady-state thermal conditions. The study further suggests that passive IRT can be a practical tool for monitoring temperature distribution and assessing the thermal behavior of AM polymer components under operating-like thermal loads.

返回资讯频道